Baby Crib Advice and Tips

Congratulations, you just learn that you are having a baby. Whether your first or not you need to watch cribs. Have you already? Is it an antique? A second hand crib so ancient and did not need to be studied carefully. For the safety of your new baby. The screws, bolts, and / or other fasteners should all be in place. Are they free? Does the position of the mattress hold under the weight of your baby? It is imperative that this be tested before putting your baby in its cradle. Take something that approximates the weight of your baby about four months. Bounce is the mattress to be certain it will hold its position. If it does could cause serious injury to your baby or for worse. When installing the nursery (if it is not already up) consider very carefully if you place the feeder. If you place the crib near a window and you have Venetian blinds, either shorten the cords or anchor them somewhere that your baby can reach and get a hold of them. If it all possible avoid placing the bed near the window. As your baby grows into a toddler and he / she tries to get out of the crib, / s, it could fall, causing serious injury to your baby. http://www. babies and toddlers. moneybizhome. Blankets com and your baby are not necessarily a good mix. With the incidents of SIDS today, you want to be sure everything that could possibly put your child at risk. It is wiser to put your baby to bed in a bed. If you absolutely must have a blanket over the baby, tuck tightly around and under the foot of the mattress with your baby’s feet touching the footboard. So you do not want to put all coverage on the baby than up to his chest as that will help prevent slipping under the blankets and suffocating. Bumper pads are a great concept, but unless they are secured properly, there is a risk of your baby slipping between the mattress and the bumpers and possibly suffocating. If you use them they should be anchored in at least eight places one at each corner of the crib and at least two spaced evenly on each side. There should be a total of 16 links in total, for the top and bottom. Mobiles are a nice addition and we lovely but. . . The caveat here is that if you use a mobile phone when your baby starts to sit on his own motives should be taken to prevent your baby from becoming entangled in it. Also make sure it has no small removable parts that your baby could choke. If your baby is second hand, no matter if you had a previous child or you got someone else to check carefully the mattress. Make sure there are no cracks or holes in the mattress cover. Also make sure that the mattress is snug in the crib. Again, your child could slip between the mattress and the sidebars or the end boards and suffocate. The mattress should fit snugly in the crib. Now the sheets you use in your baby’s bed should also fit properly and not slip. Sheet anchors are available that hook on the sheet under the mattress and hold it in place. The position of the mattress is imperative for the safety of your child. Most parents put the mattress in the highest position when the baby comes first home because it is so easy to change in this position. As your baby becomes more active, you want to lower the mattress accordingly. Once your baby can pull up to standing position put the mattress in the lowest position possible and to be sure your baby safely, measure the distance between the top of the sidebar and mattresses . In the lowest position the distance from the top of the sidebar does not exceed 26 inches above the mattress. If your child’s head is on the sidebar or they get out of bed, it may be time to move your child to a regular bed. Some beds are convertible into beds tat will grow with your child. The crib itself should be looked over for things that might put your baby at risk. Have you seen those cribs that have ornate designs carved into the end boards? They are beautiful, but they represent a danger to your child. Your child may have head or arm and leg caught and sustain an injury. The simplest design of the crib the safer your child may be. Since about 1974 federal guidelines for security beds state that the slats should not be more than 2 3 / 8 inches. This is to prevent your baby from getting his head stuck between the slats. This could cause harm to your baby, but it would require the removal of some of the blades and that alone could compromise the safety of your baby. http://www. baby. moneybizhome. com